Replacing The Scsi Cable; Floppy Cable; Removing The Floppy Cable - Sun Microsystems SPARCstation Voyager Service Manual

Replacing the SCSI Cable

1. Connect the SCSI cable to the I/O board.
See .
FIGURE 8-4
Note – Check both ends of the SCSI connector to make sure it is lined up with the
I/O board socket.
2. Replace the disk drive.
See Section "Replacing the Hard Disk Drive" on page 9-94.
3. Close the system and power it on.

Floppy Cable

Removing the Floppy Cable

1. Remove the CPU board.
See Section "Removing the CPU Board" on page 10-96.
2. Remove the video board.
a. Place an antistatic surface on your work area.
b. Press the speaker at both tabs lightly and pull it out of its cavity.
See .
FIGURE 8-5
Chapter 8 Major Subassemblies 73