A-3-2 Procedure To Make The Ethernet/Ip Connection Settings With The Sysmac Studio - Omron NX Series User Manual

Settings for the originator device
NX-series Controller
POWER
PORT2
(NX-series EtherNet/IP
Unit
Two EtherNet/IP ports)
(Two built-in
EtherNet/IP ports)
NJ-series Controller
(CPU Unit built-in
EtherNet/IP port or
EtherNet/IP Unit)
Tag and tag set settings
Setting with the Sysmac
Studio is possible.
Use the Network Configurator if a CS/CJ-series PLC operates as the originator device.
Settings for the originator device
CS-/CJ-series PLC
Setting only with
the Network Configurator is possible.
A-3-2
Procedure to Make the EtherNet/IP Connection Settings with the
Sysmac Studio
1 Registering devices
↓
2 Creating network variables
NX-series EtherNet/IP Unit User's Manual (W627)
Settings for the target device
NX-series Controller
(NX-series EtherNet/IP
Unit
Two EtherNet/IP ports)
(Two built-in
EtherNet/IP ports)
NJ-series Controller
(CPU Unit built-in EtherNet/IP port
or EtherNet/IP Unit)
CS-/CJ-series PLC
FH/FZ/FQ/ZW-series Sensor
or another similar unit
Connection settings
Setting with the Sysmac
Studio is possible.
Settings for the target device
NX-series EtherNet/IP Unit
Register devices with which the EtherNet/IP connections
are established to the project.
--- Refer to Registering the Net-
*1
work Variable for the Origina-
tor Device on page A-13.
POWER
PORT2
Tag and tag set settings
Setting with the Sysmac
Studio is possible.
Tag and tag set settings
Setting only with the Network
Configurator is possible.
Tag and tag set settings
Settings not required.
POWER
PORT2
Appendices
•
Main Window
Setup Window
Global Variable Table on the
Sysmac Studio
A-7
A