Omron NX Series User Manual page 155

IP address = 192.168.250.2
Target node ID = #002
NX-series EtherNet/IP Unit
Controller Status
Variable a
Variable b
Variable c
Additional Information
The target node ID may be duplicated depending on the IP address of the target node. In this
case, it is necessary to change the target node ID on the Network Configurator so that the
same address could not be used by more than one node.
For information on how to change the target node ID, refer to Step 4 under Registering Devices
in the Register Device List in Connection Settings in 9-2-5 Connection Settings on page 9-32.
When you use multiple connections to communicate with one specific node, the information of the
Controller status is stored in the following variables if the Controller status is specified in the input tags
and the output tags for all the connections.
NX-series EtherNet/IP Unit User's Manual (W627)
Value of last byte = 2
Controller status (when included)
Output tag set
Connection
EtherNet/IP
9 Tag Data Link Functions
EIP_Comm1Status.TargetPLCModeSta[2]
(CIP Communications1 Target PLC Operating Mode)
0
1
2
254
255
CJ-series CPU Unit
Controller status
I/O memory
Input tag set
Variable f
Variable g
Variable h
Controller status (when included)
Target data link status
9-11
9