Omron NX Series User Manual page 392

14 Troubleshooting
Connection status
General Additional
Status Status
(hex) (hex)
01 0107
01 0108
01 0109
01 0110
01 0111
14-56
Source of error
Error code returned from target:
Attempted to close a connection, but that
connection was already closed.
Error code returned from target:
Attempted to open a connection with an
unsupported connection type.
Error code returned from target:
The connection size settings are differ-
ent in the originator and target.
Error code returned from target:
The target was unable to open the con-
nection, because of its operating status,
such as downloading settings.
Error code returned from target:
The RPI was set to a value that exceeds
the specifications.
Handling
Configuration Configuration
1 2
This error does This error does
not occur. not occur.
This error does Check which
not occur. connection
types can be
used by the
target.
(Contact the
manufacturer.)
Only multicast
and point-to-
point connec-
tions can be
set.
Check the connection (sizes) set in the originator
and target.
Check whether Depends on
the tag data the target's
link is stopped specifications.
at the target. (Contact the
(Restart the tag target device's
data link com- manufacturer.)
munications
with the soft-
ware switch.)
This error does Check the tar-
not occur. get's RPI set-
ting specifica-
tions.
NX-series EtherNet/IP Unit User's Manual (W627)
Configuration
3
This is not an
error because
the connection
is already
closed.
Check which
connection
types can be
used by the
originator. (An
error will occur
if a connection
other than a
multicast or
point-to-point
connection is
set.)
Check whether
the tag data
link is stopped
at the target.
(Restart the tag
data link com-
munications
with the soft-
ware switch.)
Set the origina-
tor's RPI set-
ting to 10 sec-
onds or less.