Omron NX Series User Manual page 397

Connection status
General Additional
Status Status
(hex) (hex)
D0 0001
D0 0002
NX-series EtherNet/IP Unit User's Manual (W627)
Source of error
Error code generated by originator:
The connection operation is stopped.
Error code generated by originator:
The connection is being opened (open-
ing processing in progress).
14 Troubleshooting
Handling
Configuration Configuration
1 2
The connection The meaning
was stopped of this error
because the code is defined
Tag Data Link by each ven-
Stop Bit was dor, so it de-
turned ON, or pends on the
the settings da- target's specifi-
ta is being cations.
downloaded. (Contact the
Either turn ON target device's
the Tag Data manufacturer.)
Link Start
Switch, or wait
until the set-
tings data has
been down-
loaded.
This code in-
cludes fatal
Controller er-
rors and Unit
failure. To han-
dle these er-
rors, refer to
the NJ/NX-
series
Troubleshootin
g Manual (Cat.
No. W503).
Wait until the The meaning
opening proc- of this error
essing is com- code is defined
pleted. by each ven-
dor, so it de-
pends on the
target's specifi-
cations.
(Contact the
target device's
manufacturer.)
Configuration
3
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
14
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
14-61