Omron NX Series User Manual page 380

14 Troubleshooting
Event name Tag Data Link Started
Meaning Tag data links were started by the Network Configurator, Sysmac Studio, special instructions or manipulation of
a system-defined variable. Or, the data link table was downloaded from Network Configurator or Sysmac Stu-
dio.
Source X Bus EtherNet/IP Function Mod-
ule
Error attributes Level
Effects User program
Indicators EtherNet/IP NET RUN
Flashes at 1-s intervals.
Device variable Variable
None
Cause and cor- Assumed cause
rection
Tag data links were started by the
Network Configurator, Sysmac Stu-
dio, special instructions or manipu-
lation of a system-defined variable.
Attached infor- Attached information 1: Controller status (01 hex: PROGRAM mode, 02 hex: RUN mode)
mation Attached information 2: Operation method (01 hex: Operation by Network Configurator or Sysmac Studio, 02
hex: Manipulation by a device variable, 03 hex: Manipulation by special instructions)
Attached information 3:
•
When attached information 2 is 03 hex: IP address of the target node
•
Other than the above: 0
Precautions/ None
Remarks
14-44
Source details
Information Recovery
Continues. Operation
EtherNet/IP NET ERR
---
Data type
---
Correction
---
Event code 94040000 hex
1 to 4: Mounting Detection tim-
position of the X ing
Bus Unit (unit
number) and
CIP1/CIP2 are
given in combi-
nation
--- Log category
Not affected.
EtherNet/IP LINK/ACT
---
Name
---
Prevention
---
NX-series EtherNet/IP Unit User's Manual (W627)
At user opera-
tion
Access