Krick Sea Cruiser ARIADNE Building Instructions page 76

Clip in the jib riders at the forestay.
Now attach the two sheets from the sail winch
to the main boom and the jib boom.
Lead the main sheet through the block of the
traveller and hook it to the boom with a rigging
hook 121.
Hook the jib sheet to the jib boom with a rig-
ging hook as shown in the picture.
12.3 Installing the rudder servo
On the photo below you can see the installa-
tion of the servo for the rudder linkage.
Status July 2019
Screw two linkage connectors 206 into the
control arm of the servo and fix the rudder
linkages 208.
Finally, you can install the speed controller and
the receiver and program the remote control.
13. Flagstaff, cleats, etc.
Base for flagstaff
Using part 147 and part 148 make the foot of
the flagstaff.
147
Bevel the edge of the hole in the flange with a
round file. Then solder or glue the base and
the foot together at an angle.
Page 33
155
148
©
Krick Modelltechnik Knittlingen Germany