Krick Sea Cruiser ARIADNE Building Instructions page 78

For the tiller, glue each 2 parts 86 together.
Use a round file to file the recess for the axle
along the marking.
Now glue the two halves together and glue in
the axle. Make the axle from pos. 177. Re-
move the screw head.
Status July 2019
Now grind the tiller. You can now stain the tiller
if desired and then prime it with pore filler and
varnish it.
Now drill the hole into the deck. The position is
marked on the deck. Drill through at an angle
of 50 ° with a 4 mm drill bit.
Grind the bearing part 178 diagonally accord-
ing to the course of the deck and glue it into
the deck.
Let the tube protrude so far from the deck that
the tiller is over the edge of the cockpit.
Insert the tiller and secure with the nut, part
124.
Page 35 ©
Krick Modelltechnik Knittlingen Germany