Advertisement
Available languages
Available languages
Cut 2 x 1.5 m from the sheet rope pos. 133 for
the two sheets. Fasten the sheet to the drum of
the winch. Insert the line from the outside
through the hole to the inside and secure it
against slipping through with a knot at the end.
Wind both mainsheet and jib sheet in opposite
directions 2 turns onto the drum. Make sure
that the winch is either completely open or
tightly wound
Connect the winch to your remote control. The
remote control's stick should not be neutraliz-
ing and should preferably be completely open.
Now place the drum on the winch. If you now
close the winch, the complete sheet way will
be wound up.
Now insert the winch into the servo board.
Push the two sheets through the deck lead-
throughs.
Now mount the traveller on the brackets of the
cockpit. For this purpose drill 2 holes with 1.7
Status July 2019
mm diameter into the brackets and screw in
the supports part 129.
The grating of the cockpit should now be in-
serted.
Hook a block into a ring pos. 167. Push the
brass wire (pos. 128) through and hook the
ring with block.
129
Install the grating in the cockpit before gluing
the traveller 128.
Stain the grating accordingly, prime with pore
filler and then varnish.
12.2. Attach sails
After the mast is up, the sails can be attached.
First of all, slide the mainsail into the boom.
Page 30
130
©
Krick Modelltechnik Knittlingen Germany
128
Advertisement
