Advertisement
Available languages
Available languages
Next fit the support part 36 and glue with 5
min. epoxy or Stabilit.
Assemble the rudder linkage from the rudder
lever part 173, set collar 174 with screw 175
and the ball heads 156.
Screw 175
155+156
(not shown)
157
If you want to install the auxiliary drive, this
should be done in the next steps.
Status July 2019
36
173
174
Page 5
5. Motor preparation, installing the ballast
Solder the interference-suppression capacitors
on the engine so that the two capacitors 103
(value 10 nf) each run from the terminal lug to
the engine housing. The engine housing must
be sanded very well at the soldering point.
Solder the third capacitor 473 (value 47 nf)
between the two terminal lugs. Insulate the
capacitor legs with shrink sleeve wrapping.
Next, solder the connecting cables.
Now the electric motor can be screwed onto
the engine mount.
Put together the engine mount.
©
Krick Modelltechnik Knittlingen Germany
Advertisement
