Krick Sea Cruiser ARIADNE Building Instructions page 66

same is done in the next step with the jib
boom.
166
Now make the jib boom.
D 2 mm
104
119, 169
121
Drill a 2mm hole at one end of the jib boom. At
the other end drill 2 holes for the jib sheet.
Here also the brackets pos. 120, bent to the
angle, are used.
Hang a swivel pos. 119 into the 2 mm hole with
a ring. At the other end of the swivel hook a
rigging hook pos. 121. With this hook the jib
boom will be hooked to the boat later.
Status July 2019
167
D 1,8 mm
Page 23
Also for the jib boom, angled tabs for clew and
jib neck are pushed into the keep. Here the
keep has to be extended slightly with a file.
Now all components of the rig are finished and
you can install the mast.
10. Rig up
First attach the eye bolts for fixing the shrouds
and stays.
For this purpose drill the holes in the upper
deck and screw in the eye bolts 123 with
washer 180. Use a 2.5 mm diameter drill bit.
©
Krick Modelltechnik Knittlingen Germany