Xcc System Management Port Leds - Lenovo ThinkSystem SR675 V3 User Manual

AP0 LED (Green)
1
Table 26. LEDs description
Scenario
RoT security module fatal
firmware failure
No system power (FPGA
heartbeat LED off)
XCC firmware recoverable
error
XCC firmware is recovered
from error
UEFI firmware authentication
failure
UEFI firmware is recovered
from authentication failure
System is OK (FPGA
heartbeat LED is On)

XCC system management port LEDs

This topic provides information on LEDs of XCC system management port.
The following table describes the problems that are indicated by LEDs on XCC system management port.
ThinkSystem SR675 V3 User Guide
234
AP1 LED (Green)
2
Fatal
AP0 AP1
Error
LED LED
LED
Off Off On
Blink N/A On
Blink N/A On
Off Off Off
Blink N/A Off
On N/A Off
N/A Blink Off
N/A On Off
On On Off
Fatal Error LED (Amber)
3
FPGA XCC
heart- heart-
Actions
beat beat
note note
LED LED
Replace the firmware and RoT
N/A N/A
security module.
Replace the firmware and RoT
N/A N/A
security module.
Replace the firmware and RoT
On N/A
security module.
If the AC power is on, but the
system board assembly does
not have power, then:
1. Check the power supply
Off Off
2. If the PSU or PIB is good,
Information only. No action is
N/A N/A
required.
Information only. No action is
N/A N/A
required.
Information only. No action is
N/A N/A
required.
Information only. No action is
N/A N/A
required.
Information only. No action is
On On
required.
unit (PSU) or power
interposer board (PIB) if
any. If the PSU or PIB has
any error, replace it.
do the following:
a. Replace the system I/
O board.
b. Replace the processor
board.