Warmup Ime; Estimated Adjustment Ime; Procedure - Agilent Technologies 8711C Service Manual

Warmup Time
Allow the analyzer to warm up for one hour.
stimated Adjustment Time
his adjustment takes approximately two minutes to perform.

Procedure

1. Press
PRESET SYSTEM OPTIONS
5
Execute Test
103 ENTER
5 5
2. his is a fully automated adjustment handled by the internal rmware. Follow the
instructions on the analyzer's display. If you are using the voltage reference source, note
that no connection is needed other than the 12 pin connection cable.
If the analyzer fails the adjustment test, resulting in a warning message, check the
connections, voltages, and switch positions, then rerun the test.
not
3. If you are
going to make any more adjustments, press
Update Corr Const
are
If you going to make more adjustments, save the correction constant data that you have
generated so far.
a. Insert a formatted disk into the internal disk drive.
b. Press
SYSTEM OPTIONS
a le (or writes over an existing le) where the correction constants are stored.
2-20 Adjustments
ervice Test and Adjustments
5
.
.
tore CC to EPROM
ervice Update Corr Const
5
elect Adjustment
ervice
SYSTEM OPTIONS
5
. his creates
tore CC to Disk