Re Ection (One-Port) Correction, Adjustment #107; Required Equipment; Warmup Ime; Estimated Adjustment Ime - Agilent Technologies 8711C Service Manual

Re ection (One-Port) orrection, Adjustment #107
his procedure corrects for errors in re ection measurements. he analyzer measures an open,
a short, and a load to perform a one-port re ection calibration.
equired Equipment
Equipment
escription
Calibration kit
Warmup Time
Allow the analyzer to warm up for one hour.
stimated Adjustment Time
his adjustment takes approximately three minutes to perform.

Procedure

1. Press
PRESET SYSTEM OPTIONS
5
Execute Test
107 ENTER
5 5
2. Follow the instructions on the screen.
not
3. If you are going to make any more adjustments, press
Update Corr Const
are
If you going to make more adjustments, save the correction constant data that you have
generated so far.
a. Insert a formatted disk into the internal disk drive.
b. Press
SYSTEM OPTIONS
a le (or writes over an existing le) where the correction constants are stored.
Recommended Model or Part Number
50
HP 85032B/E
ervice Test and Adjustments
5
.
.
tore CC to EPROM
ervice Update Corr Const
5
75
HP 85036B/E
elect Adjustment
ervice
SYSTEM OPTIONS
5
. his creates
tore CC to Disk
Adjustments 2-29