Installing An Ambient T/H Sensor - Huawei UPS5000-H-1200K-NT User Manual

Hide thumbs Also See for UPS5000-H-1200K-NT:

Table of Contents

UPS5000-H-(1200 kVA-1600 kVA)

User Manual (100 kVA Power Module)

Figure 4-415 Cable connection for an NO EPO port

4.11.3 Installing an Ambient T/H Sensor

If an ambient T/H sensor is configured, perform the following steps to install it.

Step 1 Secure the fastener of the ambient T/H sensor to the wall or ceiling near the UPS.

Figure 4-416 Securing the fastener

Step 2 Install the T/H sensor on the fastener.

Issue 07 (2022-11-29)

● When you use the NC status, remove the jumper between EPO_NC and EPO_12V first.

When you turn off the EPO switch, EPO is triggered.

● When you use the NO status, ensure that the jumper is connected between EPO_NC and

EPO_12V. When you turn on the EPO switch, EPO is triggered.

4 Installation and Cable Connection