Huawei UPS5000-H-1200K-NT User Manual page 226

UPS5000-H-(1200 kVA-1600 kVA)
User Manual (100 kVA Power Module)
Figure 4-194 Hole dimensions (unit: mm)
(A) Mounting holes on the
channel steel
(1) Top air-flow cabinet
(4) Inductor cabinet
Step 2 Install expansion sleeves for expansion bolts.
1.
2.
3.
4.
Knock the expansion bolt into the hole until the expansion tube completely fits
into the hole. The expansion sleeve must be completely buried under the ground
to facilitate subsequent installation.
Issue 07 (2022-11-29)
NO TE
Use the marking-off template delivered with the fasteners for installation against a wall to
determine the mounting holes for a cabinet.
● If the cabinet is 800 mm wide, you do not need to cut the marking-off template. Drill
holes at the positioning holes marked 8.
● If the cabinet is 600 mm wide, cut the marking-off template along the 600 mm dotted
line, and drill holes at the positioning holes marked 6.
● If the cabinet is 400 mm wide, cut the marking-off template along the 400 mm dotted
line, and drill holes at the positioning holes marked 4.
Drill a hole into the concrete floor using a hammer drill.
Partially tighten the expansion bolt and vertically insert it into the hole. Knock
the expansion bolt using a rubber mallet until the expansion sleeve is fully
inserted into the hole.
Tighten the expansion bolt.
Remove the bolt, spring washer, and flat washer.
NO TICE
Copyright © Huawei Digital Power Technologies Co., Ltd.
(B) Mounting holes on the
floor
(2) Power cabinet 1
4 Installation and Cable Connection
(C) Front door direction of the
cabinet
(3) Power cabinet 2 + bypass
cabinet
217