Configuring An X.25 Link On The Arn - Nortel CC MIS User Manual

TCP/IP switch links using ARN

Configuring an X.25 link on the ARN

This section describes the procedure for configuring an X.25 link on the
ARN router. After the link is configured on the ARN, the CC MIS system
can connect to the DMS switch through the ARN.
Before starting this procedure, you need the following information:
The COM port on the ARN router to use for this link.
The DNA of the NOP link on the DMS switch (an eight-digit X.121
address). It can be found in DMS tables MPCLINK and NOPADDR.
The required X.25 link speed (9600, 19200 or 56K baud).
Whether the X.25 link to the switch uses a direct cable connection or
synchronous modems.
The TCP port number to assign to this link (in the range 12304 to
16399). CC MIS connects to this port to initiate a connection to the
switch.
Starting Site Manager on the PC
To start Site Manager, use the steps in Procedure 75.
Procedure 75:
1 On the Windows Start menu, choose Programs > Site Manager >
PC_Site Manager.
The main Site Manager window appears (see Figure 133 on page 395).
396
Starting the Site Manager application
Call Center Management Information System
Standard 2.0