Reboot The System - Nortel CC MIS User Manual

Shutdown, startup, reboot, and power down

Reboot the system

The Reboot the System command allows support personnel to remotely
reboot the system without on-site intervention. That is, a local person at the
remote site is not required to reboot the system.
Perform the steps in Procedure 21 to reboot the system.
Procedure 21:
1 Access the Maintenance and Administration main menu.
2 Type r to display the Run State Utilities menu.
3 Enter r to reboot the system.
The system displays the following warning messages:
Shutdown the system and restart
This command shuts down the CC MIS application (if it
is currently running), then shuts down and restarts
the operating system.
Ready?
4 Type y to reboot the system.
Note: To quit and return to the Run State Utilities menu, type q.
The system displays the following messages:
Broadcast message from root (pts/0)
(Tue Mar
The system is going down for reboot NOW!
System reboot requested. You will now be logged out.
Press RETURN to continue.
5 Press <enter>.
The Maintenance and Administration interface is logged off.
172
Rebooting the system
(yes/quit)
1 08:07:58 2005):
Call Center Management Information System
Standard 2.0