Dmslink Messages - Nortel CC MIS User Manual

System Log messages

DMSLINK messages

Introduction
This section contains the error message generated by the DMSLINK
subsystem of the CC MIS product.
Note: The CC MIS product runs on a Down Stream Processor, therefore the
error messages do not appear in the switch log.
Informational messages
The following messages do not indicate an error condition but are used as
notification of significant events which occur as part of normal operation.
Call data transfer beginning...
The switch has acknowledged the request to begin transferring call event
data. (Action Code: J)
Connected to switch <ip_addr:port>
The CC MIS system has successfully connected to the switch identified by
the given IP address and port number. (Action Code: J)
End of initialization data download...
The switch has completed the initialization data download. (Action Code: J)
Initialization data download beginning...
The switch has responded to the request to send initialization data and is
about to start the initialization data download. (Action Code: J)
Initiating a nosLogon...
DMSLINK is sending a nosLogon request to the switch. (Action Code: J)
482 Call Center Management Information System
Standard 2.0