Removing A Wallboard From The System - Nortel CC MIS User Manual

May 2007
c. Enter the address for the wallboard:
Spectrum—two-digit number (01–99 set by the remote keypad)
Daktronics—a six-digit number (supplied in the wallboard)
Generic—not meaningful and is automatically set to 1 by the system
d. Press the Edit Field function key and enter name in the Name field.
e. Press the End Editing function key.
10 Select the Commands function key, and then select Save and Exit to
save the configuration.
Changing the configuration of a wallboard
You can change the configuration of a wallboard or rename a wallboard.
Use the steps in Procedure 37 on page 233 to access the Wallboard screen,
and then edit the configuration using the Options and Edit Field function
keys, as applicable.
To move a wallboard from one port to another, remove the current definition
of the wallboard and then add the wallboard definition at the other port
using the steps in Procedure 37.
Only one type of wallboard can be used on a port. A total of five wallboards
are supported for each port. (Only one generic wallboard for each port is
supported.)

Removing a wallboard from the system

Use the Delete function key to remove a wallboard from the system.
CC MIS Installation and Maintenance
Local partitions
235