Bar Messages - Nortel CC MIS User Manual
Call center management information system
Hide thumbs
Also See for CC MIS:
- Release note (86 pages) ,
- Getting started manual (137 pages) ,
- User manual (374 pages)
Table of Contents
Advertisement
May 2007
BAR messages
Introduction
This section contains error messages generated by the Backup and Restore
(BAR) Process of the CC MIS product.
Note: The CC MIS product runs on a Down Stream Processor, therefore the
error messages do not appear in the switch log.
This section lists only those messages which are unique to the Backup and
Restore Process. Messages listed in "Standard error messages" on page 456
may also be generated by this process.
Warning messages
This section lists the warning messages that may be generated by BAR.
These messages usually indicate an unusual condition that can be
appropriately handled by the process, and which does not prevent the
process from continuing execution.
Nightly backup failed: yyyy
This message is logged whenever a restore is started through the
maintenance Restore screen. (Action Code: J)
Nightly backup failed
This message is logged whenever the nightly backup fails after it has been
successfully initialized. (Action Code: W)
Ad hoc backup failed
This message is logged whenever an ad hoc backup fails. (Action Code: W)
Restore Failed
This message is logged whenever a restore fails. (Action Code: AA)
CC MIS Installation and Maintenance
System Log messages
547
Advertisement
Table of Contents
