Nortel CallPilot Administrator's Manual page 110

110 Chapter 7 Security recommendations
•
In addition to the activities list, the system deposits an alarm message in
the alarm mailbox, if the alarm mailbox is configured and these events are
not throttled.
When you accumulate enough data about the hacker attack, you can
disable monitoring of the offending source to avoid excessive logging. You
can disable monitoring by using one of the following methods:
•
•
To monitor SMTP/VPIM
Step
1
2
3
4
5
6
7
Copyright © 2007, Nortel Networks
.
all unauthenticated connections (that is, where authentication was not
attempted)
Click Delete to remove the monitoring activity from the list.
Click Disable to disable the monitoring activity.
This retains the activity in the list so that you can enable it again, if
required.
Action
On the CallPilot Manager toolbar, navigate to Messaging > Security
Administration.
Under the SMTP/VPIM section, click the checkbox Enable
Monitoring Activities.
Click Add.
Select Activity Type (IP Address, FQDN or User ID)
Enter a value for your selected activity type, and then click Save.
Click OK to confirm that the record is updated.
Result: A window appears with the following message: "Record is
updated."
Click OK.
Result:The Security Administration screen appears with your added
entry under Activities to Monitor.
Note: If you would like to delete or disable any of these activities,
check the box next to the activity and click on Delete or Disable.
Nortel CallPilot
Administrator Guide
NN44200-601 01.11 Standard
5.0 9 November 2007
—End—