Nortel BCM50 2.0 Configuration Manual page 53

Table 14 Capabilities panel fields (Sheet 2 of 3)
Attribute Values
Pickup group None
1 to 9
Page zone Page zone
(1 to 6)
None
Direct dial Set 1 to Set 5
None
Intrusion Protection None
Level
Low
Med
High
HF answerback <check box>
DND on Busy <check box>
Paging <check box>
Auto hold for <check box>
incoming page
Priority call <check box>
Description
Assigns this telephone to a pickup group (a group where all
telephones ring until one is answered).
Assigns this telephone to a page zone.
A zone is any group of telephones that you want to group together
for paging, regardless of their location. You can assign one of six
zones to each telephone.
The maximum number of digital telephones in a page zone is 50.
The maximum number of digital and IP telephones in a page zone
is 60.
Defines whether you can call the direct dial telephone from this
telephone using the direct dial digit.
If the break-in feature is allowed on any private network MCDN
lines (PRI SL-1) assigned to the telephone, you must define the
level of intrusion for each telephone. This determines if the user
can use the feature, and to what degree.
None: feature is turned off, user cannot break in on any calls
Low: user can only break into calls on other telephones with low
level protection
Med: user can break into calls on other telephones with low and
medium-level protection
High: user can break into calls on all other telephones with this
feature
Defines whether you can answer automatically a voice call without
lifting the receiver, or pressing the Handsfree button.
Note: The feature is not available on model, i2001,7000 and 7100
telephones.
Speaker volume: Note that the speaker volume on the telephone
returns to the default volume setting determined by the telephone
for each new handsfree call.
Defines whether an incoming call rings if you are already on
another call.
Defines whether you can make paging announcements from this
telephone.
Not selected - If the telephone is active when a page comes in, the
page does not come through the telephone set.
Selected - If the telephone is active when a page comes in, the call
is placed automatically on hold and the page continues.
Note - 7XXX digital phones:
• Condition - When this setting is enabled, an active call is on
mute when the page comes in.
• Results after page - The call is taken off hold, but is no longer
muted.
Defines whether this telephone can interrupt calls or override Do
Not Disturb at another telephone.
Chapter 6 DN records parameters
Device Configuration Guide
53