Nortel BCM50 2.0 Configuration Manual page 242

242 Chapter 27 Display prompts and messages
Display prompt
No calls waiting
No free lines
No last number
No line to use
No line selected
No line selected
No number saved
No number stored
No voice call
Not available
Not HG member
Observe
Not in service
Not in service
CANCL RETRY
Not in service
CALLBCK
Not in Service
Observe
NN40020-300 NN40020-300
Description of error or action
You tried to use Call Queuing but no call was ringing at your telephone.
FEATURE
SWCA: The
are no calls parked on any of the assigned buttons on your telephone.
All the lines or line pools available to the telephone are in use. This prompt also
appears when you try to dial an external number, or use a feature that conflicts with
the lines, line pools, or prime line used by the telephone. Your installer must correct
this situation.
You have not dialed an external telephone number since the last power interruption
or system reset.
Line redirection: You have one external line on your telephone, but you need a
second line to perform line redirection. Redirect your external line using a line pool as
the outgoing line.
Auto dial or Speed dial: The telephone is set up to dial an external number on a
prime line, but the telephone does not have a prime line. Your installer must correct
this situation.
There is no call ringing at your telephone. If you have a flashing line button, but your
telephone is not ringing, press the line button to answer the call on that line.
Saved number redial: You have tried to save the number of an incoming call. You
can only save numbers that you have dialed.
Speed dial: There is no number stored on the speed dial code you have dialed.
Message: No number programmed for the message center. Contact your voice
messaging service provider.
Voice call: The telephone receiving the call cannot accept voice calls for one of the
following reasons:
• The telephone is active or ringing with another call.
• Call Forward is on.
• Do Not Disturb is on.
• Voice Call Deny is on.
• It is not a BCM telephone.
• Your call continues as a normal ringing call.
You tried to use a feature that is currently not available from your system.
Transfer: The telephone where you directed a call is not in service or is or
unavailable. The call returns to your telephone.
Silent monitor: The DN you entered is not a Hunt Group member. Press
to enter another hunt group telephone.
Call forward: Two or more telephones are linked in a forwarding chain, and one is out
of service or used for programming.
Transfer: The telephone to which you are trying to transfer a call is out of service.
Camp-on: The telephone to which you have camped a call is out of service or is used
for programming. The call has returned to you. Press
reconnect to the call. On 7000 and 7100 digital phones, lift the handset to reconnect
with the call.
Silent monitor: The DN you entered did not respond to the system. Press
to enter another hunt group telephone.
FEATURE
*537 or *538 request was used, but there
Observe
CALLBCK or the line button to
Observe