Nortel BCM50 2.0 Configuration Manual page 37

• Some features also require that the service be available on the line from your telephone service
provider. The types of lines provided are also determined by the region chosen for your
system. MCID (malicious call identification) is an example of this type of feature.
Table 7 Button Programming Feature settings (Sheet 1 of 4)
Set command
(FEATURE Feature
<code>)
None
0 Speed dial
1 Send message
#1 Cancel send message
2 Ring again
3 Conference/Transfer
4 Call forward
5 Last number redial
*5 Language choice
60 Page - general
61 Page - Internal
62 Page - External
63 Page - speaker and zone Allows the user to page through both the internal sets, and externally
64 Line pool
65 Reply message
#65 Cancel message waiting
66 Voice call
67 Saved number redial
68 Restriction override
69 Priority call
*7 Contrast
70 Transfer
Chapter 5 System features and feature codes
Description
Indicates a button that is configured for button programming, but nothing
has been entered.
Activates the speed dial feature. The telephone prompts the user for a
speed dial code.
Allows the user to send a message to another DN on the system.
Allows the user to cancel a message that was sent to another set within
the network.
Turns on the Ring again feature.
Initiates a conference between user and two parties.
Allows the user to enter a number to forward all calls.
Note: Allow redirect must be selected to forward calls outside of the
system.
Causes set to redial the last number that was dialed.
Allows the user to select the language in which prompts are displayed.
Initiates a page.
Allows the user to page internal to a specific zone, which is identified
within the Button programming. (For example F611 internal zone 1, F610
page internal all zones.)
Allows the user to page through the speaker on a specific telephone.
connected paging equipment to a specific zone, which is identified within
Button programming.
Allows the user to access a line pool. The pool this button accesses is
specified during Button Programming for this feature.
Allows the user to access messages, and send a reply to the message
sender.
Allows the user to cancel the message waiting indicator.
Allows the user to make an announcement, or begin a call through the
speaker of another telephone.
Allows the user to redial a number that was saved while on a call.
Allows the user to override any restrictions on the set or line with a CoS
password.
Allows the user to priority call an internal DN that is currently busy.
Allows the user to adjust the contrast of the display screen.
Allows the user to transfer an existing call to another telephone or
external number.
Device Configuration Guide
37