Nortel BCM50 2.0 Configuration Manual page 239

Display prompt
Feature code:
QUIT
Feature moved
<Feature name>
SHOW OK
Feature timeout
Forward>NNN
CANCL
Forward denied
Hidden number
Hold or release
Inactive feature
Incoming only
In conference
INFO
In observe:
Monitor
Intercom #: ___
QUIT
Intercom
In use:XXX
Invalid code
Description of error or action
FEATURE
Feature button: Press
the button. Check that the code is valid.
Feature button: You have programmed a button with a feature programmed on
another button. The feature has moved to the button you just programmed. The
original button is now blank.
Button inquiry: The name of the feature assigned to a button appears on the display
when you press the button. Press # or
You took more than 15 seconds to press a button in response to a display.
Call forward: Your calls are being forwarded to telephone NNN.
Call forward: There are several reasons why you can receive this message. For
example, you cannot forward your calls to a telephone that has Call Forward
programmed to your telephone.
The last number you dialed, or the number you saved for Saved Number Redial, was
a speed dial number that displayed a name instead of the number. You dialed the
number correctly, but it is not visible.
While on a call, you must either release the call, or place the call on hold, before you
can program a feature button.
SWCA: The requested SWCA code already has a call parked on it. Choose another
key position.
You entered the feature code for an application that is disabled.
The line you are trying to use to redirect calls is for incoming calls only. Select an
outgoing line.
The active call display of the former conference master.
Silent monitor: The hunt group member is being monitored already.
Auto dial: Enter the internal telephone number you want to program.
Line redirection: You selected the intercom button as the facility on which to place
the call. Enter a line pool code or a destination code.
You tried to program redirection while the feature is in use. Only one person can
program line redirection at a time.
SWCA: The requested SWCA code is being used by telephone XXX. Choose
another key position.
Message: You are trying to call from your message waiting list. The line that you are
trying to use is in use by the identified user in your system.
You entered an invalid feature code.
Speed dial: You have entered a code outside the code range (01-70 for system,
71-94 for user-based speed dials).
Chapter 27 Display prompts and messages
and enter the feature code you want to assign to
for additional information.
SHOW
Device Configuration Guide
239