Nortel BCM50 2.0 Configuration Manual page 244

244 Chapter 27 Display prompts and messages
Display prompt
Pick up receiver
Please wait
Pool code: ___
QUIT
Press a button
QUIT
Press a line
Press held line
Program and HOLD
Program and OK
QUIT OK
Programmed
Priority> NNN
BLOCK
Priority denied
Redir by NNN
OVERRIDE
Redirect denied
Release a call
NN40020-300 NN40020-300
Description of error or action
You have used the Call Queuing feature without lifting the handset. Auto Handsfree
is not assigned to your telephone. You must use the handset, or press the handsfree
button to answer a call.
Priority call: The party you are calling has eight seconds to decide to accept or reject
your priority call.
Line redirection: Enter a valid line pool access code.
Auto dial: Press the memory button you want to program.
Button inquiry: Press the button you want to check. Press
when finished.
Move button: The button you are trying to move is not a line button. If you are trying
to switch a line and a feature, move the line to the feature button, not the feature
button to the line.
Conference call: You have activated the Conference feature with one call active and
another on hold. Press the held line to bring that person into the conference.
Auto dial: Enter the number you want to program on the button, then press
Speed dial: If you want to program a line or line pool selection for this speed dial
number, select the line or line pool. If not, enter the telephone number exactly as if
you were dialing it normally. When you are finished, press
Enter the number you want to program on the button, then press
can include a line or line pool selection in an auto dial sequence by selecting the line
before entering any digits.
Speed dial: If you want to program a line or line pool selection for this speed dial
number, select the line or line pool. If not, enter the telephone number you want to
program exactly as if you were dialing it normally. When you are finished, press
The number is stored correctly on the button.
You are receiving a priority call. If you are on another call, tell the person to whom
you are speaking, that you are about to place the call on hold. Press the flashing line
indicator of the priority call, or wait until the call connects automatically (in eight
seconds). The priority call goes through after you hear the next beep. Your active call
is on Exclusive Hold. It reconnects automatically when the priority call ends (unless
you transfer the priority call, in which case, you must press the line button of your
original call to reconnect). Use DND (
priority call.
Priority call: The telephone you are calling is receiving a priority call at the same time,
or cannot receive priority calls.
Line redirection: You have tried to redirect a line, but another person has redirected
that line. Press * or OVERRIDE
line.
Line redirection: You can redirect calls only on individual lines.
You have no free line available to receive a call. Release one of your current calls,
and try again to answer the incoming call.
Camp-on: The line that the camped call is on is in use, or that line does not appear at
your telephone. Release the line or release an internal line.
FEATURE
85) or press
to override the previous redirection and redirect the
FEATURE
or EXIT
HOLD
.
HOLD
.
HOLD
or OK . You
.
OK
BLOCK to reject a