Nortel BCM50 2.0 Configuration Manual page 295

Figure 64 Music panel
Table 91 Music parameters (Sheet 1 of 2)
Setting
Music Source
Audio Jack
Server
Server RTP port
Stream Type
Frames per packet
Music Manager control
Launch Music Manager Launch the Music Manager Administration web page
Server
Server RTP port
Stream Type
Frames per packet
Definition
Select Audio Jack if you are using an external music source that is connected to the MSC
card on the BCM.
Select Music Manager if you are using the IP Music feature to connect to the music source
available on the BCM. If you select Music Manager, you must then configure the BcmAmp
application before you can use it. For information about how to configure BcmAmp, refer to
"Configuring Music Manager" on page
Select Streaming Server if you are using the IP Music feature to connect to a music
source on the data network. If you select Streaming Server, you must configure the
Network Device before you can use it. For information about how to configure the Network
Device, refer to "Configuring a Network Device to be the IP Music Source" on page
Note: A third party application, that supports streaming G.711, is required.
Field not required.
Field not required.
Field not required.
Field not required.
Field not required.
Field not required.
Field not required.
Field not required.
Chapter 30 Configuring the music source
297.
Device Configuration Guide
295
301.