Nortel BCM50 2.0 Configuration Manual page 51

Figure 11 Capabilities and Preferences table panel
Table 13 describes the fields shown on the main Capabilities and Preferences tabbed panel.
Table 13 Capabilities and Preferences tabbed panel (Sheet 1 of 2)
Attribute Values
DN <read only>
Model <alphanumeric>
Name <numeric>
Prime Line None, Pool (A to O),
I/C (intercom),
Line: <line number>
Intercom Keys 0 to 8
Control Set DN: <any telephone
DN>
None
DN:221<start DN>*
Description
Refer to "Main panel tabs: common fields" on page
Refer to "Main panel tabs: common fields" on page
Refer to "Main panel tabs: common fields" on page
Choose the first line that the telephone selects when a call is
made.
PRI Bloc pools are not valid selections for a Prime line.
When you assign a line pool as a prime line, the system searches
automatically for an idle line in the pool.
Assign the number of intercom buttons to a telephone.
Intercom buttons provide a telephone with access to internal and
external lines, and to line pools.
The Control telephone attribute allows you to define a DN that
acts as a control telephone.
A control telephone is used to enable/disable Scheduled Services,
such as Restriction Services, for the telephones to which it is
assigned. For more information about services, see
schedule settings and services scheduling" on page
You can assign several control sets for your system, but you can
only assign one control telephone per DN.
* If you change the Start DN, this number reflects that change.
Chapter 6 DN records parameters
Device Configuration Guide
51
42.
42.
42.
"System
29.