Nortel BCM50 2.0 Configuration Manual page 47

Table 10 Telephone line assignment fields (Sheet 2 of 3)
Attribute Values
Caller ID set <check box>
Vmsg Set <check box>
Note: Contact your voice message service provider to find out if your voice
message service works with BCM, or if you have any problems with your service.
Priv. Received # These fields reflect the settings defined under target lines.
(Target lines only) These are the digit strings that the system uses to identify a call for this telephone.
Refer to "Trunk/Line Data, main panel" in the Networking Configuration Guide
Pub. Received #
(NN40020-603).
(Target lines only)
Actions
Add To add a line to a telephone:
1. On the System DNs table (Line Access tab), choose the DN record where you
2. Under the Assigned Lines table in the bottom panel, click Add.
3. Enter a line number in the dialog box.
4. Click OK to save the line to the list.
Description
This prompt only appears for target lines, and for any analog
lines that provide CLID through a GATM (not all markets).
When enabled, the telephone displays call information when
it is available for a call before answer.
When disabled, no call information is displayed for this line.
Choose this setting if the telephone does not have a display,
or if you do not want call information displayed to the user.
Disabling this function can reduce system resource
requirements.
Limitation: Only 30 telephones can have this field enabled
for any given line.
Select whether an indicator shows on the telephone for a
voice message waiting on an external voice message
system.
The line must appear on the receiving telephone.
Note: The Message Waiting Indicator (MWI) is currently
supported exclusively by Meridian Mail and CallPilot and
SL-100, and DMS-100.
MCDN note: If your system is part of an MCDN network
connected to a Meridian 1 system, and you are using the
voice mail system off the Meridian 1, you must enable this
field.
Analog lines connected to legacy analog ASM station
modules, and analog telephones attached to an ATA device,
do not provide visible message waiting indication. Analog
telephones connected to a GASM8 support message
indicators, if the telephone is set up to receive them.
want to add lines.
Chapter 6 DN records parameters
Device Configuration Guide
47