Nortel BCM50 2.0 Configuration Manual page 241

Display prompt
Line denied
Line in use
Line Redirection
QUIT ADD REMOVE
Messages & Calls
MSG CALLS
Make calls first
Message denied
Message list
SHOW ADD EXIT
Message to:
Microphone muted
Move line from:
QUIT
Move line to:
QUIT
Need Handsfree
No avail SWCA
No button free
No call to park
No call on: 101
Description of error or action
You selected a line that is private to another telephone.
Trunk Answer: You have tried to pick up a call on a private line.
The line is in use. Make the call using normal methods, or wait until a line is free.
Line redirection: Press * or
previous redirection.
Message: You have one or more messages, and one or more new Call Logs. Press
FEATURE
806 to change the first line of the display to the current time and date.
The feature you tried to use requires you to be on an active call at your telephone.
This prompt also appears when information about a call is cleared by a system reset.
Message: You tried to send a message to an invalid internal number, or to a
telephone that is out of service.
Message: SHOW appears when you have remaining messages. Press
review messages you have sent. Press
Message: Enter the internal number of the telephone to which you want to send a
message.
Voice call: Your handsfree microphone is on the mute setting. Press the button
labeled Handsfree/Mute, or pick up your handset to respond to the voice call.
Move button: Press the button of the line you want to move. Press
when you have finished moving lines.
QUIT
Move button: Press the button of the line to which you want to move the current line.
Neither of the buttons is erased. The lines, or the line and feature, switch places.
Silent monitor: You entered the silent monitor feature code without lifting the
handset, and the telephone does not support Handsfree operation.
SWCA: The FEATURE *520 request was unsuccessful, either because the
telephone has no associated SWCA keys, or all the SWCA keys for that telephone
are associated with other calls.
Note: If the call is an internal call and the destination set has a SWCA associated
with the call, and if the originating set requests that the call be associated with a
different SWCA, then the destination telephone transfers the call to the new SWCA
position. If the destination telephone does not have a button programmed for the new
SWCA position, the call disappears from all SWCA button appearances, and can
only be retrieved by entering the corresponding SWCA code.
You tried to make, receive, or pick up a call when no line button was available. Some
features require you to have a button free. Releasing calls can free up line buttons.
Message: You have no line button free with which to reply to a message.
Call park: You have tried to use Call Park with no active call on your telephone. If the
call you want to park is on hold, reconnect to the call before you park it.
Call park: There was no call on the retrieval code (101-125) that you entered.
Chapter 27 Display prompts and messages
ADD to begin redirection. Press # or
to send a new message.
ADD
REMOVE to cancel a
SHOW to
FEATURE
Device Configuration Guide
241
or