Nortel BCM50 2.0 Configuration Manual page 38

38 Chapter 5 System features and feature codes
Table 7 Button Programming Feature settings (Sheet 2 of 4)
Set command
(FEATURE Feature
<code>)
71 Link
74 Call park
*520 Find available SWCA key System searches for a free SWCA key among the SWCA keys that are
*521 to *536
System Wide Call
Appearance (1 to 16)
*537 Find oldest SWCA call
*538 Find newest SWCA call
*550 Silent monitor
75 Group pickup
76 Directed pickup
77 Call timer
78 Pause
79 Exclusive hold
800 Trunk answer
801 Call queuing
802 Group listening
803 Time
804 Wait for dialtone
806 Static date and time
807 Ringing (Signal) call
808 Long tones
811 Call information
812 Call log - view
information
813 Call LogIt
NN40020-300 NN40020-300
Description
Activates the Link command, which allows the user to access special
features on a remote PBX system.
Allows the user to park a call.
assigned to the current telephone.
Non-intercom calls are associated with an available SWCA key when the
call is answered, originated, or placed on Hold.
Features that interact with this feature: Hold, telephone keys, outgoing
and incoming calls.
System searches among the SWCA keys assigned to the telephone, and
unparks the call that has been parked the longest.
System searches among the SWCA keys assigned to the telephone, and
unparks the most recently parked call.
Allows the user to monitor hunt group calls. (Telephone must be
assigned with SM supervisor.)
Allows the user to answer a call ringing telephone within the Pickup
group.
Allows the user to answer any ringing telephone within the same system.
Allows the user to see the call duration timer.
Allows the user to insert a pause during a dialing sequence.
Allows the user to place a call on hold at the current telephone. All
appearances of the call on other telephones indicate the line is busy.
Allows the user to answer a ringing line while in a ringing service. (If
enabled).
Allows the user to answer calls in order when several calls arrive in rapid
succession. Calls are presented in this order: incoming calls, timed-out
forwarded calls, then camped calls.
Activates the speaker on the set to allow a group of people to hear a call.
But the user must talk to the caller through the handset.
Briefly displays the current time.
Places a pause in a dialing string that holds the following digits until a
dialtone is perceived on the line.
First line displays the date and time.
Directly rings another telephone inside the system when an extension is
entered after the feature is selected. This is the same process as
pressing an intercom button and dialing an extension.
Allows the user to send long DTMF tones.
Allows the user to view information about a current call.
Allows the user to view call log information.
Allows the user to add the current call to the call log manually.