Nortel BCM50 2.0 Configuration Manual page 45

Table 9 Line Access - System DNs table fields (Sheet 2 of 2)
Attribute Value
Priv. OLI <numeric>
*If your system allows outgoing name and number blocking, the telephone must have a valid OLI.
Fwd No up to 24 digits
Answer
Fwd Delay 2, 3, 4, 6, 10
Fwd Busy up to 24 digits
Fwd All up to 24 digits
Chapter 6 DN records parameters
Description
Define the originating line identification number (OLI) that
appears on the telephone being called from this telephone
over a private network.
Note: On systems running DID, this field is populated
automatically with the DN.
On PBX systems, this field is populated automatically only if
the DN length and the Received # length are the same.
If the DN length or the Received # length are changed to be
different from each other, this field is cleared.
Also refer to "Configuring CLID on your system" in the
Networking Configuration Guide (NN40020-603).
Enter the number to which you want to redirect unanswered
incoming calls.
Define the number of rings before the system forwards an
unanswered call.
This heading only appears after you enter a Call Forward No
Answer number and press Enter.
Default: 4
Redirect incoming calls when this telephone is busy with
another call.
This setting is the same as using FEATURE 4 at a telephone.
When this feature is active, all calls to this telephone are
forwarded to the destination entered in this field.
If you are forwarding calls to a remote location, ensure that
you include the required destination/access codes.
A user can press FEATURE #4 to cancel this feature.
Device Configuration Guide
45