Nortel BCM50 2.0 Configuration Manual page 245

Display prompt
Release calls
Restricted call
Restricted call
CANCL RETRY
Ring Again?
YES NO EXIT
Select a line
Select line out
QUIT
Select line(s)
QUIT ALL
Select line(s)
ALL OK
Send message?
YES NO
Set locked
SetNam2 SetNam3
NEWCALL TRANSFR
Start of list
NEXT
Still in trnsfer
CANCL RETRY
Supervisor
Observe
Description of error or action
You tried to use a feature while you were on a call or had calls on hold. Release the
call, or calls, before using the feature.
Silent monitor: You entered the silent monitor feature code on a telephone that
already has an active call. To continue, you must place that call on hold, or release it.
The destination you selected for line redirection is restricted.
System programming has a restriction configured for the call you are trying to make,
such as time-of-day restrictions for some calls.
Transfer: You cannot transfer the call because of telephone or line restrictions.
Press YES to use Ring Again. Press
Either you have no prime line, or the prime line is in use, or the line programmed for
an auto dial number, speed dial number, or Hotline is in use. Select a line and dial
again.
Speed dial: There is no line related with the speed dial number you are trying to use.
Select a free external line or line pool and enter the speed dial feature code again.
Line redirection: Select the line used to redirect calls out of the system.
Line redirection: Press the lines to redirect. To release a line selection, press the line
to redirect again. Press ALL
Cancel redirection: Press the lines that no longer need redirection. The lines light up
when pressed. After you cancel redirection for a line you cannot restore it by
pressing the line again. Press
HOLD
finished, press or
Line redirection: Continue to press the lines to redirect. Press
finished.
Cancel redirection: Continue to press the lines that no longer need redirection. Press
HOLD
or OK when finished.
Press YES to send a message. See Messages.
You cannot use the feature you selected because your telephone is locked.
The active call display for a three-party conference master.
Message: You are at the beginning of your list of messages. Press
through your messages.
Transfer: Complete the transfer in progress before you access a new feature, answer
another call, or select an outgoing line.
Silent monitor: The DN you entered belongs to another Supervisor. You cannot
monitor SM supervisor telephones. Press
telephone.
Chapter 27 Display prompts and messages
NO to send a message.
to redirect all your lines.
ALL to cancel redirection for all your lines. When
OK .
Observe
HOLD
or OK when
to move
NEXT
to enter another hunt group
Device Configuration Guide
245