Kubota SSV65 Operator's Manual page 83

OPENING AND CLOSING OF COMPONENTS
Raising (Tilt up)
1. Select a firm, level surface, lower the lift arms fully
to the ground, and stop the engine.
2. If the lift arm must be up while raising the operator
cab, install the lift arm support device.
(See HOW TO USE THE LIFT ARM STOPPER on
page 43)
3. Put the jack stands under the rear corners of the
frame.
(1) Jack stand
4. Set the armrest to the raised position.
5. Remove the stopper pin from rear of the machine
and remove the lock bolts from the front of the
machine.
(1) Lock bolt
6. Slowly raise the cab until the cab is all the way up
and the stopper latching in engages.
NOTE :
• The required force to lift the cab is affected
by the temperature.
SSV65,SSV75
(1) Cab
Fig [A]
(2) Stopper
7. Set the stopper lock to the locked position.
(1) Stopper lock
Lowering (Tilt down)
1. Set the stopper lock to the release position.
MAINTENANCE
(A) Fig [A]
(B) Raise
(C) Engage
(A) Locked position
79