Safety Features; How To Use The Emergency Exit; How To Use The Function Of The Armrest; How To Use The Opc Function - Kubota SSV65 Operator's Manual

SAFETY FEATURES

SAFETY FEATURES
WARNING
To avoid personal injury or death:
• Place the machine on a firm, flat and level
surface
• Before starting the engine, make sure that no
one is near the machine.
HOW TO USE THE
EMERGENCY EXIT
This window is equipped with latches. If you should
become trapped in the cab, you can open the rear
window to get out.
1. Turn both latches clockwise until they disengage
from the window frame.
2. Push the rear window out of the rear of the operator
cab.
3. Exit through the rear of the operator cab.
(1) Window
HOW TO USE THE FUNCTION
OF THE ARMREST
1. Sit in the operator's seat.
2. Fasten the seat belt.
3. Start the engine.
4. Push down both the armrests.
5. Push on the hydraulic-unlock-switch, and make
sure that the hydraulic-lock-indicator
instrument panel goes out.
6. Move the right control (front operating) lever slowly,
and make sure that the lift arms and bucket move
slowly.
42
(2) Latch
on the

HOW TO USE THE EMERGENCY EXIT

7. Raise the left armrest, and make sure that the
hydraulic-lock-indicator on the instrument panel
lights up.
8. Move the right control (front operating) lever, and
make sure that the lift arms and bucket do not get
activated.
9. Push down the left armrest.
10. Push on the hydraulic-unlock-switch, and make
sure that the hydraulic-lock-indicator
instrument panel goes out.
11. Raise the right armrest, and make sure that the
hydraulic-lock-indicator on the instrument panel
lights up.
12. Move the right control (front operating) lever, and
make sure that the lift arms and bucket do not get
activated.
When checking the function of the armrest, also check
the OPC function.
(See HOW TO USE THE OPC FUNCTION on page
42)
HOW TO USE THE OPC
FUNCTION
WARNING
To avoid personal injury or death:
• While checking the OPC function, you start the
engine without wearing the seat belt. After
making sure that the OPC function gets
activated as specified, be sure to fasten the seat
belt and operate the machine.
Make sure that the armrests function as specified in
HOW TO USE THE FUNCTION OF THE ARMREST on
page 42, and then check the OPC function.
1. Sit in the operator's seat.
2. Start the engine.
3. Push down both the armrests.
4. Push on the hydraulic-unlock-switch, and make
sure that the hydraulic-lock-indicator on the
instrument panel goes out.
5. With the armrests kept down, get off the operator's
seat, and make sure that the hydraulic-lock-
indicator on the instrument panel lights up in 3
seconds.
During lighting up of the hydraulic-lock-indicator, be
careful not to touch the control levers and the foot
pedals.
on the
SSV65,SSV75