Long Storage; Storing The Machine For Alonger Period Of Time; Operating The Machine After Storing For A Long Period Of Time; Periodic Replacement Of Important Component Parts - Kubota SSV65 Operator's Manual

LONG STORAGE

LONG STORAGE
WARNING
To avoid personal injury or death:
• Do not clean the machine with the engine
running.
• To avoid the danger of exhaust fume poisoning,
do not operate the engine in a closed building
or any areas without proper ventilation.
• When storing the machine, remove the key from
the starter switch
persons from operating the machine and
getting injured.
• Bring the machine on a firm, flat, and level
surface. Lower the lift arms on the ground.
STORING THE MACHINE FOR A
LONGER PERIOD OF TIME
If the machine be stored for a longer period of time,
follow the following procedures.
1. Clean the whole machine thoroughly and in all
cases store it indoors.
If you have to keep the machine outdoors, follow
the following procedure.
a. Lay out wooden planks on even ground.
b. Place the machine on the planks.
c. Cover the machine completely.
2. Change the oil and grease the machine.
3. Heavily grease the visible section of the cylinder
rods.
4. Remove the battery and store it indoors.
5. If it is expected that the ambient temperature will
drop as follows, add the antifreeze or drain coolant
completely.
Ambient temperature
6. Inflate the tires to the recommended pressure
shown in the operator's manual.
7. Fulfill the fuel tank and the hydraulic oil tank.
IMPORTANT :
• Wash the machine after stopping the engine.
If you wash the machine while running the
engine, splashing water gets into the air cleaner
through its intake and cause engine damage.
Carefully, wash and do not splash water over
the air cleaner while the engine is running.
120
to avoid unauthorized
below 0 ℃
STORING THE MACHINE FOR A LONGER PERIOD OF TIME
OPERATING THE MACHINE
AFTER STORING FOR A LONG
PERIOD OF TIME
Follow the following procedures when operating
the machine storing for a long period of time.
1. Wipe off the grease from the hydraulic cylinder
rods.
2. Turn on the engine, and operate the attachments
and the drive mechanisms under no load in order to
circulate the hydraulic oil.
If the machine is stored for longer than one month,
perform steps 1. and 2. once every month.
1. Periodic replacement of important
component parts
To ensure safety in operation, you are strongly
requested to inspect and service the machine at regular
intervals. For added safety, ask your KUBOTA dealer to
replace the following important component parts.
The following important component parts are prone to
degradation in material or subject to wear and tear with
time. It is difficult to judge how much they have been
affected at regular inspection. It is therefore necessary
to replace the following component parts with new
ones, whether wear is visible or not after a specified
time of use.
If any parts are found worn even before the specified
use, repair or replace them in the same way as other
parts.
If any of the hose clamps is found deformed or cracked,
also replace the hose clamp.
For the hydraulic hoses other than the ones to be
replaced periodically, inspect them for the following
points. If found unusual, tighten them up or replace
them.
When replacing the hydraulic hoses, change their O
rings and sealings with new ones.
For replacement of the important parts, contact your
KUBOTA dealer.
NOTE :
• At the following periodic inspections, check the
fuel hoses and hydraulic hoses as well.
SSV65,SSV75