Operating The Attachment Control Device (Option) - Kubota SSV65 Operator's Manual

AUXILIARY HYDRAULIC
4. Operate the AUX hydraulic control.
• Tilt the AUX-port-variable-switch toward side (A)
or press the right AUX-hold-switch.
Oil starts flowing out of the male port.
• Tilt the AUX-port-variable-switch toward side (B)
or press the left AUX-hold-switch.
Oil starts flowing out of the female port.
(1) AUX port variable switch
(2) AUX hold switch
IMPORTANT :
[High-Flow mode only]
• In the High-Flow mode, operate the machine
with the male-port-switch (A) of the right-
control-lever.
• When operating the machine with the
female-port-switch (B) of the right-control-
lever, standard-flow oil passes through the
female port.
NOTE :
• The oil flow rate responds to the tilt of the
AUX-port-variable-switch.
• Operating the AUX hydraulic control with the
AUX-hold-switch, the oil continues to flow at
its highest flow rate. To interrupt the oil flow,
press AUX-hold-switch again or tilt the AUX-
variable-switch to either direction.
5. If the tank must be drained, depending on an
attachment in use, use the male-case-drain-port.
62
(A) Male port
(B) Female port
HOW TO USE THE AUXILIARY HYDRAULIC CONTROL
(1) Male port
(2) Female port
2. Operating the attachment control
device (option)
You can use the attachment-control-device to feed
electrical power for an attachment. For instance, to
drive a valve.
With the AUX port ready for use, you can supply power.
Use K (+12 V) and B (GND) of the 14-pin coupler
attached on the arm. See the following figures and
table.
NOTE :
• The K (+12 V) of the 14-pin coupler turns on
when the starter switch is in [RUN] position.
(1) 14-pin coupler
(3) Male case drain port
SSV65,SSV75