Cleaning The Plastic Parts And Synthetic Leather; Service For Tires; Precautions For Handling The Tires; Checking The Tire Pressure - Kubota SSV65 Operator's Manual

MAINTENANCE
IMPORTANT :
• If the purging was insufficient, the engine dies
after starting. In this case repeat step 2. again.
4. Cleaning the plastic parts and
synthetic leather
• Use a soft cloth when wiping plastic parts or
synthetic leather.
• If the plastic or synthetic leather is very dirty, use a
soft cloth dipped in a mild detergent that has been
diluted with water.
• Wipe off any remaining moisture or detergent with a
soft cloth that has been moistened with water and
then thoroughly wrung out.
• Cleaning the plastic parts with alkaline, acidic, or
organic solvents such as alcohol or benzene can
damage them.

SERVICE FOR TIRES

1. Precautions for handling the tires

WARNING
To avoid personal injury or death:
• Before handling the tires, set the parking brake,
stop the engine,
attachment to the ground, release the hydraulic
pressure in the hydraulic system by operating
the control levers, lock all control levers in
neutral, and remove the starter key.
• When raising the tire, block up the chassis for
safety.
• Before adding the air, install the tire correctly
on the machine or put the tire in a retaining
device (tire-inflation-cage). Do not blow up the
tires with greater pressure than specified in the
following table because a blown tire can cause
serious injury.

2. Checking the tire pressure

1. Check the tire pressure.
(See Checking the tire pressure on page 89)

3. Changing the tires

WARNING
To avoid personal injury or death:
• Before jacking up the machine, park it on a firm
and level ground.
• Select jack stands that withstand the machine
weight and set them up as shown below.
106
lower the bucket and
(1) Jack stands
(1) Wheel nut
Removal
1. Loosen the wheel nuts, each by one turn on the
wheel to be removed.
2. Lift the machine so that the wheel to be removed is
just raised off the ground.
3. Place the machine on jackstands.
4. Then remove the wheel nuts and remove the wheel
from the axle.
Fitting
1. Mount the wheel on axle and lightly tighten the
wheel nuts.
2. Lower the machine to the ground, and tighten the
wheel nuts to the specified torque in the order
shown in the following table and figure.
Tightening
Wheel nut (1)
torque
SERVICING AS REQUIRED
200 N⋅m to 220 N⋅m
(20.4 kgf⋅m to 22.5 kgf⋅m)
SSV65,SSV75