Auxiliary Hydraulic; How To Use The Auxiliary Hydraulic Control; Operating The Auxiliary Hydraulic Control - Kubota SSV65 Operator's Manual

HOW TO USE THE AUXILIARY HYDRAULIC CONTROL

AUXILIARY HYDRAULIC

HOW TO USE THE AUXILIARY
HYDRAULIC CONTROL
WARNING
To avoid personal injury or death:
• Do not exceed the rated operating capacity of
the unit. If loads exceed the rated operating
capacity, the unit can experience a hydraulic
imbalance when half or medium "lift arms raise"
and "bucket roll back" or "auxiliary hydraulic
control" commands are input together, which
can result in the lift arms lowering slowly. If you
begin to experience a hydraulic imbalance,
either place the lift arms control in neutral or
input full raise control, and lift arms lowering
will cease.
• Stop the engine and relieve pressure before
connecting or disconnecting lines.
• Do not use your hand to check for leaks.
Connecting
1. Remove dirt or debris from the surface of both the
male and female couplers, and from the outside
diameter of the male coupler.
2. Visually check the couplers for corroding, cracking,
damage, or excessive wear. If any of these
conditions exist, the coupler must be replaced.
3. Push the quick couplers tightly and hold for a few
seconds, the pressure is relieved automatically
(Pressure relief system).
4. Connect the couplers.
(1) Male coupler
(2) Female coupler
IMPORTANT :
• Ensure that hydraulic hoses connecting the
attachment to the vehicle are long enough.
SSV65,SSV75
(3) Male case drain coupler
Otherwise the couplers could be damaged due
to frequent side loading and tension during use.
Disconnecting
1. Push the quick couplers tightly and hold it for a few
seconds, the pressure is relieved automatically
(Pressure relief system).
2. Detach the couplers.
1. Operating the auxiliary hydraulic
control
WARNING
[High-Flow model only]
To avoid personal injury or death:
• Be careful not
incompatible attachment
mode. Otherwise the attachment may be
damaged.
• Certain high-flow attachments may require the
use of a protective door (polycarbonate) such
as a hammer or mulcher.
1. Start the engine.
(See Starting the engine on page 53 and Start of
the machine on page 55)
2. Press the hydraulic-unlock-switch.
3. Press the AUX port switch.
(1) Hydraulic unlock switch
AUXILIARY HYDRAULIC
to use any High-Flow-
in the High-Flow
(2) AUX port switch
61