Kubota SSV65 Operator's Manual page 15

5. Stop the engine.
6. Remove the key.
PRECAUTIONS FOR SAFELY
LOADING AND TRANSPORTING
THE MACHINE
• Observe all regulations concerning the transport of
the machine on public roads.
• Use adequately long and robust ramps when
loading the machine. Block the ramps, and
transport the machine appropriately.
If towing is required, use proper tow lines and
attachment points.
For details, see LOADING THE MACHINE ON A
TRANSPORT VEHICLE on page 71.
• To avoid tipping over, the heaviest end of the unit
should proceed up the ramps first, do not change
the running direction, and do not swing the
attachment crosswise to the loading ramps.
• Lower the attachment on the loading bed and
release the pressure from the hydraulic system.
After loading the machine on the truck, secure the
tires with blocks and tie down the machine at the
appropriate locations.
(1) Chain
• Avoid abrupt braking of the vehicle with the
machine loaded. Sudden braking could cause the
machine to move and could cause a serious
accident.
PRECAUTIONS FOR
MAINTENANCE
1. Preparing maintenance
Before performing maintenance work on the machine,
following the procedure.
1. Place the machine on a firm, flat, and level surface.
2. Lower the lift arms slowly to the ground.
3. Stop the engine.
4. Remove the key.
SSV65,SSV75
(2) Block
SAFE OPERATION
Start maintenance work carefully, for example, loosen
the plug slowly so that oil will not squirt out.
2. Checking items for maintenance
• When dismantling hydraulic parts, make sure that
the hydraulic oil has cooled down sufficiently to
avoid burns.
• Let the machine cool down sufficiently before
working on the engine, the exhaust system, the
radiator and the hydraulic system.
• Turn off the engine at all times when filling with fuel.
Avoid spilling and over-filling of fuel.
• Do not smoke while refueling or using the battery.
Keep sparks and fire away from the fuel tank and
the battery. Flammable gases escape from the
battery, especially during charging.
• Make sure that the fueling system is properly
grounded.
• Read and follow the directions of Starting the
engine with an auxiliary battery on page 54 when
starting with an auxiliary battery.
• Keep a first-aid box and extinguisher at hand at all
times.
• Do not open the radiator cap before the radiator
has cooled down sufficiently.
1. First loosen the cap to the first stop and allow
the system enough time to release the
remaining pressure.
2. Then loosen the cap completely.
• Failure to follow proper procedures when mounting
a tire on a wheel or rim can produce an explosion
which may result in serious injury or death. Do not
attempt to mount a tire unless you have the proper
equipment and experience to perform the job.
When inflating the tire, use a self-holding chuck and
a remotely-operable shut valve as well. Keep
blowing up the tire away from it. Have it done by
your Kubota dealer or a qualified tire repair service.
• Always maintain the correct tire pressure. Do not
inflate tires above the recommended pressure
shown in the operator's manual.
11