Agilent Technologies 86038A User Manual page 92

Function Reference
Preset
Table 4 Default values
Function
Dispersion Measurement Type
Active Ports
Measurement Start Wavelength
Measurement Stop Wavelength
Normalization Range
Resolution, Trace Points
Resolution, Increment
RF Modulation Frequency
Auto Modulation Frequency
Sensitivity, IF Bandwidth
Sensitivity, Samples/Point
Dynamic Drift Reduction
a for 81600B-160 TLS: depends on TLS type
b
Varies by trace type.
Preset Display Properties
Wavelength Meter
92
Cancels any current operations and sets the instrument to defined setup
conditions (state).
Preset Value
GD/CD Swept
Port1
a 1493 nm
a 1640 nm
Use Measurement Settings
1601
a 0.08125 nm
2000 MHz
Off
300 Hz
1
Off
Resets all the settings contained in the Display menu to their default
values. It differs from a normal preset in that measurement settings and
trace data are preserved.
Uses the 86122A multi-wavelength meter to determine a wavelength
offset correction for the TLS during the Normalization process. To use this
function, the Low SSE output of the TLS must be connected to the 86122A
during normalization. The wavelength meter is used only during
normalization and not before or during actual measurements.
Function
a
X-Axis Scale, Minimum
a
X-Axis Scale, Maximum
a
X-Axis Scale, Center
a
X-Axis Scale, Span
b
Y-Axis Scale, Reference Level
b
Y-Axis Scale, Units/Division
Y-Axis Scale, Ref. Level Position
Auto Scale During Measurement
Smoothing
Curve Fit
TLS Power
Markers
Agilent 86038A Optical Dispersion Analyzer, Third Edition
System Menu
Preset Value
1493 nm
1640 nm
1575 nm
130 nm
0 ps
1000 ps
5
On
Off
Off
– 5 dBm
Off