Agilent Technologies 86038A User Manual page 114

Function Reference
Marker Setup
Marker Search
114
Show Markers
Turns the marker functions on or off.
Toggle the markers off, then on to reposition the markers near the
Tip:
center of the viewable range.
Marker Position
Allows you to enter in a specific wavelength for both marker 1 and marker
2.
If markers are turned on, the curve fit function will only apply to the
Tip:
region of the trace that is between the markers.
page 120 for more information.
Marker Search
Shortcut accesses the Marker Search panel. This is useful when using a
mouse to navigate the functions.
Marker Function
Shortcut accesses the Marker Function panel.
Allows you to move the active marker to either the peaks or pits of the
trace.
Far Left places the marker on the last peak or pit on the left side of the trace.
Next Left places the marker on the next peak or pit left of the current marker posi
tion.
Next Right places the marker on the next peak or pit right of the current marker po
sition.
Far Right places the marker on the last peak or pit on the right side of the trace.
Lowest places the marker on the lowest peak or pit amplitude on the trace.
Next Down places the marker on the next lowest peak or pit amplitude of the cur
rent marker position
Next Up places the marker on the next highest peak or pit amplitude of the current
marker position.
Highest places the marker on the highest peak or pit amplitude on the trace.
Agilent 86038A Optical Dispersion Analyzer, Third Edition
Display Menu
Refer to "Curve Fit" on