Programming Commands
Ports Property
TriggerModeParams Property
202
Read the value of this property to find out which port or ports are enabled,
or set the value of this property to select the active port or ports. This is
equivalent to pressing Ports on the front panel.
Property Value
InstrumentObjects.ODACommon.ePortsEnabled
VB.NET Syntax
odaClient.Ports =
_InstrumentObjects.ODACommon.ePortsEnabled.Port_1_Enabled
VB 6.0 Syntax
odaClient.Ports=ePortsEnabled_Port_1_Enabled
Used to read or set the instrument trigger mode.
Single sweep initiates one sweep on the measurement range. Repeat
sweep continuously sweeps until the measurement is canceled or the
instrument is set to single sweep. Most remote applications use single
sweep.
Property Value
InstrumentObjects.ODACommon.eTriggerTypeVB.NET Syntax
odaClient.TriggerModeParams =
_InstrumentObjects.ODACommon.eTriggerType.TriggerSingle
VB 6.0 Syntax
odaClient.TriggerModeParams = eTriggerType_TriggerSingle
Agilent 86038A Optical Dispersion Analyzer, Third Edition
Base Commands