2. SERVICE PROGRAM MODE
2.1 SERVICE PROGRAM MODE OPERATION
The service program (SP) mode is used to check electrical data, change
modes, and adjust settings.
2.1.1 Service Program Mode Access Procedure
How to enter the SP mode
Press the following keys in sequence.
→
NOTE: 1. The above procedure must be finished within 20 seconds.
2. Hold the final
3. When SP mode is selected , "1" blinks in the 3rd digit of the copy
counter, the Auto Image Density indicator starts blinking, and the
reduce/enlarge indicator turns off.
How to leave the SP mode
Press the
key three times,
or turn off the main switch.
NOTE: The above procedure must be finished within 20 seconds.
FSM
CÓPIA NÃO CONTROLADA
→
→
key for more than 3 seconds .
4-7
CÓPIA NÃO CONTROLADA
→
A156/A160/A162