Ricoh FT5535 Service Manual page 165

[B]
[A]
[E]
[B]
7. Insert a small screwdriver [A] under the cleaning blade release lever [B] to
release the cleaning blade [C].
8. Apply setting powder [D] to the surface of the drum, and rotate the drum with
another screwdriver [E] until the area covered with setting powder has almost
reached the cleaning blade.
9. Remove the small screwdriver [A] so that the cleaning blade will press
against the drum. Then rotate the drum clockwise with the screwdriver [E].
Check whether the drum rotates smoothly without catching the blade (if it
does not, repeat steps 7 to 9).
10. Reinstall the drum charge roller ass'y on the drum unit (2 screws, 1
connector).
NOTE: Before reinstalling the drum charge roller assy on the drum unit, be
sure that no setting powder remains on the drum. If setting powder
gets onto the drum charge roller, copy quality problems will occur.
11. Refer to Section 4 page 4-11 for Drum Initialization Procedures.
A156/A160/A162
CÓPIA NÃO CONTROLADA
[D]
[C]
[A]
[E]
5-18
CÓPIA NÃO CONTROLADA
FSM