Ricoh FT5535 Service Manual page 111

Rev. 1/26/96
Mode No.
•
°5-110 Center Erase
Margin
Adjustment †
°5-113 Coin Lock
Installation †
5-115 Duplex Image
Shift †
(Back Side
Margin)
°5-121 T/C (Total
Counter) Count
Up Timing †
•
°5-305 Auto Off Time
Setting †
°5-401 User Code
Mode †
•
°5-402 User Code
Counter Check
†
A156/A160/A162
CÓPIA NÃO CONTROLADA
Function
Adjusts the center erase margin width in
erase center mode.
SP5-908 must be at 1 for this to have
any effect.
(A4 version: 1 mm per step [Range: 8
mm
to 25 mm],
LT version: 0.01" per step [Range: 0.32" ~
1.00"])
Specifies whether coin lock is installed or
not (only for Japanese versions).
Specifies whether duplex image shift
(back side margin) is used or not.
If "YES" is selected, a 5 mm margin is
made on the right of the reverse side of
copies when making two-sided copies
from one-sided originals.
If the image shift mode has been
selected with SP5-908 and if the user
uses image shift mode, this SP mode
has no effect.
Determines whether the total counter
counts up at paper feed or at paper exit.
Sets the time to go into the auto off
condition.
After JP2 on the main board is cut, either
key counter mode or user code mode
can be selected with this SP mode.
Displays the user code counters.
The current user code is displayed in
copy counter, and the copy count for that
user code is displayed in the
reduce/enlarge indicator. Hold down the
•
" " key to display the last three digits.
Use the and
each user code counter.
4-30
CÓPIA NÃO CONTROLADA
Settings
A4 version
8 ~ 25
Default = 20
LT version
0.32 ~ 1.00
Default = 0.80
0: Not installed
1: Installed
0: NO
1: YES
0: Feed
1: Exit
1 ~ 120 minutes
(1minute per step)
(Default: 60
minutes)
0: Key Counter
1: User Code
keys to check
FSM