Drum Charge Roller Replacement - Ricoh FT5535 Service Manual

4.9 DRUM CHARGE ROLLER REPLACEMENT

[A]
1. Remove the following parts:
•
Development unit
•
Drum unit
2. Remove the drum charge roller ass'y [A] (2 screws, 1 connector).
3. Place the drum charge roller ass'y on a clean sheet of paper as shown.
4. Remove the gear [B] (one E-ring) and remove the snap ring [C].
5. Remove the drum charge roller [D] while sliding the bearing [E] in the
direction of the arrow as shown in the diagram.
NOTE: 1. Never touch the surface of the drum charge roller.
2. If there is any dirt on the surface of drum charge roller, wipe it off with
a dry cloth or a special cloth for the drum charge roller. (The special
cloth is available as a service part: A1539004) Never use alcohol or
water to clean the drum charge roller.
A156/A160/A162
CÓPIA NÃO CONTROLADA
[C]
5-26
CÓPIA NÃO CONTROLADA
[E]
[D] [B]
FSM