Ricoh FT5535 Service Manual page 613

3.8 STAPLER SWITCH
The stapler switch [A] below the grip assembly cuts the dc +24 V supply to
the stapler. In proof mode, all bins lower and push the lever [B]. This opens
the stapler switch so that the signal to the stapler is cut. In sort and staple
modes, all bins are advanced and the switch is closed so that the signal can
be supplied to the stapler.
– Staple Mode Disabling Conditions –
1. Under the following conditions, staple mode is disabled.
•
If there is paper in a bin before the main switch is turned on.
•
If the selected paper size does not match the stapling specifications.
•
If the paper is fed from the by-pass feed table.
•
If the stack or interrupt modes are selected.
2. Under the following conditions, staple mode is canceled if it had been
selected.
•
If paper is inserted into a bin by hand while the staple mode is
selected.
•
If only one sheet is delivered to the bin.
•
If the number of sheets to be stapled exceeds the stapler capacity.
SM
CÓPIA NÃO CONTROLADA
4-13
CÓPIA NÃO CONTROLADA
BASIC OPERATION
[A]
[B]
A658D511.wmf
A207/A208/A211