Ricoh FT5535 Service Manual page 504

SERVICE PROGRAM MODE
Mode No.
Auto Process
Control Mode
Selection †
3-801
Free Run
(Exposure
Lamp Off)
3-901
Forced Process
Control
3-902
Exposure Lamp
Voltage
Adjustment †
4-001
Exposure Lamp
Voltage Display
°4-002 †
Vertical
Magnification
Adjustment †
4-008
A207/A208/A211
CÓPIA NÃO CONTROLADA
Function
Selects whether auto process control
mode is off or performed at the interval
shown.
If the auto process control mode is
switched off, V correction, V
R
correction, and the 1,000-copy process
control cycle will not be performed.
This SP mode can be used to help
determine whether a copy quality
problem is caused by process control or
by the machine itself.
Performs a free run with the exposure
lamp off.
Start the free run by pressing the
key and stop it by pressing the
Be sure to perform this mode without
a development unit, or too much toner
will be consumed from the developer,
causing low image density.
Performs the 1,000-copy process control
cycles forcibly.
initial adjustment → V
V
SG
detection → V
V
L ADS
adjustment
This mode starts after the
pressed.
Adjusts the exposure lamp voltage
(0.5 V per step [Range: 50.0 V to 75.0 V])
For 115 V machines, the actual applied
voltage = displayed value x 1.1412.
After doing this SP mode, ADS initial
setting (SP4-201) and forced V
detection (SP3-105) must also be
done.
See "Replacement and Adjustment -
Copy Quality Adjustments" for how to
adjust.
Displays the current exposure lamp
voltage.
(0.5 V per step [Range: 50.0 V to 85.0 V])
For 115 V machines, the actual applied
voltage = displayed value x 1.1412.
Adjusts the magnification in the paper
travel direction.
(0.1% per step [Range: –1.6% to +1.6%])
See "Replacement and Adjustment -
Copy Quality Adjustments" for how to
adjust.
1-72
CÓPIA NÃO CONTROLADA
0: OFF
1: 1,000 copies
2: 500 copies
3: 200 copies
L
!
$
key.
detection →
R
(pattern)
!
key is
50.0 ~ 75.0 V
Default = 63 V
L
50.0 ~ 85.0 V
0 ~ 32
Default = 16 ‡
Settings
‡
SM